Average Reviews:
(More customer reviews)The detection capabilities of this Radar detector are very good. It has not failed me thus far and it also filters pretty well. I give it a 3 though because I bought it specifically as I was after a cordless detector.
First issue, you need to charge the batteries first time round through the car lighter charger for 12 hrs (go figure that). Otherwise you would need to invest in a 12V switch power supply to charge outside of the car.
In any case, even after charging it, the battery life is very poor which renders this whole idea of cordless worthless.
So if you are not caught up on the cord vs cordless part, get the corded model and call it quits. You'll be satisfied.
Click Here to see more reviews about: Whistler XTR-190 Laser/Radar Detector Battery Operated with Built in Battery Charger
Whistler's XTR-190 laser/radar detector is as affordable as it is full-featured. With total band protection from radar signals, 360-degree laser detection, Whistler's patented VG-2 cloaking technology, and plenty more, you'll get an effective detector that doesn't break the bank.
Battery Powered The unit can provide approximately 15 hours of laser/radar detection with three rechargeable AA Ni-MH batteries, or you can plug it into your vehicle's cigarette lighter adapter (this will recharge the batteries).
3 City Modes/Highway Mode Highway mode provides full audio and visual warning of laser/radar systems while maintaining full sensitivity. Highway mode is the default setting of all Whistler's laser/radar detectors. City mode helps reduce the annoyance of automatic door openers and burglar alarm alerts by providing an initial alert (same distance as Highway Mode) then remaining quiet unless the signal strength becomes very strong. When the signal increases the unit will alert briefly to notify you of the change in signal strength.
Stay Alert The Stay Alert feature is designed to test a driver's alertness. Within 30 to 60 seconds after the feature is engaged an alert is sounded; to show alertness, the driver must press the volume, city or the mute button within 3-5 seconds. If a button is pressed within 3-5 seconds, the cycle is repeated. If a button was not pressed within 3-5 seconds the unit alarms at full volume and the display shows an unique visual alert.
Quiet/Auto Quiet Modes Pressing QUIET before a signal is detected engages Auto Quiet Mode, which automatically reduces the audio level after the initial warning to a low audio level setting. Pressing QUIET during a radar/laser encounter silences audio alerts, while allowing visual alerts to keep you informed.
Alert Priority When two or more signals are received at the same time, the alert priority is: Laser, VG-2, Speed Radar, Safety Radar.
Example: If X band is alerting, then suddenly a VG-2 signal is detected, the VG-2 warning will override the X band alert.
Vehicle Battery Saver Mode The Vehicle Battery Saver Mode automatically shuts off your detector within 3 hours if you forget to turn it off. The timer is reset if the detector is turned off, unplugged or any button is pressed before the 6 hours have expired. The detector will alert you with an audible and visual warning before it shuts off.
Safety Warning System--SWS This relatively new radar is not for speed detection at all, it is used to keep you informed of highway safety. Transmitters are installed and programmed (for example: in emergency vehicles) to make you aware of possible situations that may require your attention, such as: ambulance vehicles that are moving or stationary, road hazards ahead, road construction delays or detours, etc.
VG-2 Detection Mode The VG-2, also known as a "radar detector detector," is a special receiver used by police to detect signals radiated by a radar detector. The XTR-190 alerts you its presence, and thanks to Whistler's patented VG-2 cloaking technology provides undetectability.
What's in the Box Whistler XTR-190 Laser/Radar Detector, Windshield Mount, Power Cord, Three AA Ni-MH Batteries, User's Manual
No comments:
Post a Comment